Copyright by Tunturi Oy Ltd 21 All information subject to changes
TUNTURI
SERVICE MANUAL
_____________________________________________________________________________________ Version 1/2000
The relubrication must be done at regular intervals, depending on the fashion and hours of use.
For relubrication, only T-Lube must be used, as it is specifically developed for use with Tunturi
treadmills.
8.4 Lubrication pipes
The treadmill is equipped with 2 lubrication pipes, one on either side of the frame. T-Lube is
sprayed through these pipes to the inside of the belt so that the center part of the belt becomes
moist with T-Lube along the whole length. Do not apply too much T-Lube. During relubrication,
the belt should run at approximately 2-3 km/h.
To Next Page
Loading...
