UPDATING THE FIRMWARE: ONE-TOUCH CONTROLLER
25
Step 10
Step 1
Step 3
1. When the oven is off, insert the USB into
the USB port in the front of the oven.
The following display will appear after a few
minutes, touch the ‘Apply Now’ button.
Step 2
Updating The Firmware
2. The following screen will appear when the
update is in progress. The display will reset
a few times before the firmware update is
complete.
WARNING: Do not cycle power while the
firmware update is in progress.
Once the update is complete, the following
screen will be displayed with “Update
Complete.’
3. Remove the USB from the USB port.
HCT- 4201 / Rev S / January 2024HCT- 4201 / Rev S / January 2024
UPDATING THE FIRMWARE: ONE-TOUCH CONTROLLER
To Next Page
Loading...
Need help?
General