Quickstart Guide 11
5. Thru Connections
These 3-pin balanced male XLR connectors provide independent full range audio signals from
each input channel for loop-through connections to Milan two-way loudspeakers or additional
Milan subwoofers.
6. Boost
Applies +3 dB of boost with a Q factor of 1 at a centre frequency selected via the associated boost
freq control (12).
7. Limit Indicator
Illuminates red when the signal level approaches maximum and the limiters start working.
Frequent and/or continuous lighting of limit LED indicates overdriving. If this occurs reduce the
input level to the loudspeaker or enlarge your system with additional loudspeakers.
8. Signal Indicator
Illuminates green when the signal level reaches -6 dB, and is a useful indicator of the input signal
approaching the limiter threshold.
9. Power On Indicator
Blue LED illuminates when mains power is applied to the subwoofer and powered up via the
rocker switch.
10. Polarity
Reverses the polarity of the subwoofer relative to the two-way Milan loudspeakers connected to
the thru outputs.
11. Level Control
Rotary level control which attenuates the input signal level of the subwoofer and (line) from
-ā (MIN) to +43 dB (MAX).
12. Boost Freq
Selects the centre frequency at which the boost is applied, and is continuously variable from
40 Hz to 90 Hz.
To Next Page
Loading...
Need help?
General
