Page 11 of 16
939500070 Rev E
2a
2b
Replacement of Seat
Assembly
1.
Remove hardware from seat
by performing steps 1 through 6
on pages 8 and 9.
2. Remove seat by tilting the
front of the seat towards the
base of the chair (2a). Pull seat
away from the base of the chair.
When it doesn't go any farther
release the seat pan from the
seat control (2b).
3. Mount new seat pan by
inserting the front chair control
mounts into the slot.
4. Install seat and seat slide
parts (from step 1) by performing
steps 7 through 9 on page 9.
NOTE: If you have the old screw,
you must replace it with the new
screw.
3
NOTE: The rods need
to slide through the
opening in the seat pan.
OLD
TORX DRIVE
WASHER HEAD
NEW
TORX DRIVE
PAN HEAD
To Next Page
Loading...
