Press Apply or OK to save those settings. Click Cancel if you want to chance what you have changed.
Setting Report (Polling) Rate
Report rate is the frequency that the mouse reports it’s status to the Windows operating system. A setting of
1000 hertz means that it reports 1000 times per second or approximately once ever 1 mS. This is very fast. Most
modern computers are fine getting information this quickly. You only need to adjust this setting if you have a
slower computer or one that is doing a lot of other operations.
If you’d like to set it lower just click the switch corresponding to 125, 250, 500, or 1000 Hz.
Setting Lift-Off Height
You can change how high you have to lift the mouse off the surface for it to stop tracking. The default level is
medium which is approximately 1.5 mm on the Turtle Beach Drift Mousepad. Using the slider you can adjust the
lift distance from about 0 to 2.5 mm.
Experiment with levels from low to high to find the level you prefer.
Caution: While experimenting with lift distance, when you go to the lowest level, the mouse may stop tracking on
your surface. Be sure to have another mouse input device (like a trackpad or a 2
nd
mouse) so that you can still
move your cursor around and select a higher Lift-Off distance if this happens.
Setting Double Click Speed
Slide the Double Click Speed cursor back and forth to adjust the Windows double click speed from fast to slow.
After changing settings always remember to press Apply or OK to save your settings to your mouse.
To Next Page
Loading...