Tuson TPMS - Page 51

To Next Page

To Previous Page

for 3 seconds to switch back to Driving Mode. (Note: If the Tire Temperature Units is NOT

programmed within 60 seconds, the receiver will beep for a long tone to warn that the last setting

was not stored to the receiver and the display will return to Driving Mode.)

8.5 Tire Sensor ID Pairing to the Receiver

If the Tuson TPMS Retrofit Kit sensors were installed according to Section 4. TPMS Sensor Installation

and NO additional sensors will be installed for CAR 1, then Setting 8.5 can be SKIPPED for CAR 1. (Note:

If installing additional sensors not included in the kit, the “8.5 Tire Sensor ID Pairing to Receiver” MUST be

performed to install the additional sensors only.)

To pair the additional tire sensor IDs to the receiver:

8.5.1 The receiver will need to be placed close to each tire with a sensor that you would like to pair to the

receiver. If the included 12V cigarette lighter cable is not long enough to reach the tire sensors that

you would like to pair, you can use the following alternatives to reach the tire sensors:

• 12V extension cord with cigarette plug

• Tuson Display Power Cable (sold separately) to power the receiver with a 9V battery,

• 12-Volt AC/DC Power Converter

• Move the tow vehicle close to the trailer

8.5.2 If moving the tow vehicle close to the trailer, disconnect the tow vehicle from the trailer electrically

and physically if it is connected. Move the tow vehicle with the receiver unit installed close enough

to the trailer or vehicle wheels that receiver can be placed near the sensors installed in the tires.