This product is capable of processing all input signals usable in ANALOG mode.
The ANALOG input settings are as follows:
1. Press ANALOG button on the front of the product and activate the menu below.
2. Highlight the value you desire by using the UP/DOWN button and press the MENU
button to confirm your selection. From this point the OSD menu operates identically to
the MENU operations discussed above.
When using ANALOG mode, always check the input method and modify the setting as
needed for optimized output results.
2) SD 1:1 SCAN Mode
Widescreen models provide not only an UNDER SCAN mode but also an SD 1:1
SCAN mode. These modes may be selected as follows:
1. Transfer to UNDER SCAN by pressing the UNDER SCAN button on the front of the monitor.
2. Press the UNDER SCAN button again after the mode is shifted to UNDER SCAN
mode to transfer to SD 1:1 SCAN mode.
LVM-170W (G) / 230W / 240W
To Next Page
Loading...
Need help?
General
