Need help?Do you have a question about the TVS electronics BS-L100 Plus and is the answer not in the manual?
Activate scanning with a trigger pull for a single decode session.
Scanner continuously scans at user-specified intervals.
Configure buzzer settings for audible feedback.
Set data transmission speed for RS-232 communication.
Configure parity settings for RS-232 data integrity.
Configure stop bit settings for RS-232 communication.
Configure data bit settings for RS-232 communication.
Configure scanner as a USB keyboard (Plug and Play).
Select keyboard layout for USB HID mode based on country.
Configure scanner as a virtual COM port for communication.
Add prefix/suffix to scanned data for enhanced information.
Configure prefix and suffix settings for data formatting.
Enable or disable various barcode symbologies for scanning.
General| Scanning Speed | 100 scans per second |
|---|---|
| Light Source | 650 nm visible laser diode |
| Scan Rate | 100 scans per second |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 60°C |
| Scanning Technology | Laser |
| Resolution | 4 mil |
| Decoding Capability | 1D barcodes |
| Operating Current | 100 mA |
| Ambient Light Immunity | Up to 100, 000 lux |
| Interface | USB |
| Power Supply | 5V DC |
| Operating Voltage | 5V DC ± 5% |
| Drop Specification | 1.5m to concrete |
| Humidity | 5% to 95% (non-condensing) |
| Type | Handheld Barcode Reader |
To Next Page
