The LED shuts off when the BMC
controller cannot be detected or
properly initiated.
The LED blinks per second to
indicate that the BMC controller is
working normally
The CRC_ERROR pin is an optional
pin and is used when the cyclic
redundancy check (CRC) error
detectioncircuitry is enabled.
indicates that the error detection
circuitry has detected errors in the
configuration CRAM bits.
The LED shuts off when the FPGA no
error occurs during configuration.
The LED lights up when an error
occurs during configuration.
HW Sensor status is normal
HW Sensor status is abnormal.
System all power is not OK;
To Next Page
Loading...
