19
AUTOPULSE Z-20 Agent Releasing Panel Operator’s Manual (579-1165AR)
Mass Storage:
Tap Mass Storage to access the functions listed below. The USB key
must be inserted in the USB Port slot of the AUTOPULSE Z-20 CPU
Card for the Mass Storage button to work.
• Tap Job Backup to save the job currently loaded on the panel to
the USB key.
• Tap Save Reports:to save reports to the USB key.
• Tap Upgrade Status to see the progress of the software
upgrades.
• Tap SnapShot Recovery before doing a system upgrade to copy
the software types currently loaded on the panel to the USB key.
To upload these software types back on the panel, re-insert the
USB key in the USB Port of the AUTOPULSE Z-20 CPU Card and
tap SnapShot Recovery.
• Eject USB: Tap this button to safely remove the USB from the
panel.
With a USB thumb drive inserted, tap System Upgrade to open the
System Upgrade screen which contains a list of all the panel software
types and their current revisions. The software type in bold and colored
green indicates that a more recent version can be loaded on the panel.
Note: The System Upgrade screen is launched by default when the USB key is
inserted in the USB Port of the AUTOPULSE Z-20 CPU Card.
• Tap Select All to select all of the software types listed in the table.
• Tap Change Job to load a new job on the panel.
• Tap Refresh Reset to refresh the software type list.
• Tap Process Upgrade to proceed with the change.
System
Upgrade
Mass Storage
Job
Backup
Save
Reports
Upgrade
Status
SnapShot
Recovery
Eject USB
Select
All
System Upgrade
Change
Job
Refresh
Reset
Process
Upgrade
0 of 10 files selected
CARD
SOFTWARE TYPE
REVISION
0
0
0
0
0
4007H1LN
Main App
Bootloader
Kernel
Filesystem
1
302.03.02.02
1.00.00.14
1.00.00.11
1.00.00.20
Panel Setup, Continued
To Next Page
Loading...
