18
AUTOPULSE Z-20 Agent Releasing Panel Operator’s Manual (579-1165AR)
Panel Setup Overview: Use the Panel Setup function to modify the configuration of the basic panel components.
Tap on a menu icon to access that option’s main screen. Refer to Figure 6 for access levels
required to use each option inside the Panel Setup screen.
Screen Buttons:
Scroll Up
Scroll down
Accept
Return
Figure 8. Panel Setup Screen
Panel Setup
Swap Config
Set Time/Date
Touchscreen
Calibration
Mass
Storage
USER
BUTTON 1
USER
BUTTON 2
USER
BUTTON 3
Date
Time
Swap Config:
Tap Swap Config to access the functions below. These functions allow
roll back to the previous versions of the panel firmware.
• Tap Show Alternate Config Version to display the previous
version of the panel firmware.
• Tap Use Alternate Config Version to install the previous version
of the panel firmware.
Set Time/Date:
Tap Set Time/Date to access the screen where the date and time
displayed at the panel can be updated:
1. Tap the button that corresponds to either day, month, year, hour,
minute or second.
2. Enter a new value using the touchscreen keypad.
3. Repeat steps 1 and 2 for the date and time values that remain.
4. Tap Accept for the new date and time to take effect immediately.
Touchscreen Calibration:
Tap Touchscreen Calibration to access the calibration screen and
adjust the sensitivity of the user interface touchscreen. Follow these
steps to adjust:
1. Increase or decrease the touchscreen sensitivity by using the Scroll
Up and Scroll Down buttons.
2. Tap Calibrate and then tap the + signs that appear to adjust the
precision of the touchscreen pressure sensors.
3. Return to the System Menu screen.
Continued on next page
Swap Config
Show Alternate
Config Version
Use Alternate
Config
USER
BUTTON 1
USER
BUTTON 2
USER
BUTTON 3
Date
Time
Day Month
Year
Hrs Mins
Sec
::
12
3
4
56
7
89
0
Panel Setup
0101 01
01 01
01
Date
Time
Calibrate
Clear
Sensitivity
3x
Panel Setup
Date
Time
Panel Setup
To Next Page
Loading...
