Tyco AutoPulse Z-20 - Report Menu; Report Menu Overview; Alarm Log Report; Trouble Log Report

27
AUTOPULSE Z-20 Agent Releasing Panel Operator’s Manual (579-1165AR)
Report Menu Overview:
Tap Report Menu to access the Report Menu screen, where various types of reports
on the system points can be generated. To generate a report:
1. Tap Report Menu from the Main Menu screen to open the Report Menu screen
(Figure 13).
2. A report can either be saved to a USB key or printed. See instructions below for both
options:
Printing a Report Saving a Report to a USB Key
1. Tap Options and then tap Select to
choose a printer.
2. In the Report Menu screen, tap a report
button to print the report.
1. Insert the USB key inside the USB
Port of the AUTOPULSE Z-20 CPU
Card.
2. Tap a report button to save the report
to the USB key.
Note: Tapping a report button without first inserting a USB key or choosing a printer generates an
error message stating that hardware could not be found.
Refer to Figure 6 for access levels required to use each option inside the Report Menu
screen.
Screen Buttons:
Scroll Up
Scroll Down
Return
Figure 13. Report Menu Screen
Report Menu
AlarmLog
TroubleLog
TrueAlarm
Status
TrueAlarm
Service
USER
BUTTON 1
USER
BUTTON 2
USER
BUTTON 3
TrueAlarm CO Active List Verification Tally
Date
Time
Options
Alarm Log:
Tap AlarmLog to generate a report containing the list of alarms that the panel has received.
Trouble Log:
Tap TroubleLog to generate a report containing the list of Troubles that the panel has received.
TrueAlarm Status:
Tap TrueAlarm Status to generate a report containing the status of the various TrueAlarm devices connected to the
panel. The report includes the following information:
• Device Number
• Custom Label
• Current Sensitivity of the Point
• Point Status: Normal, Trouble, Alarm
• Almost Dirty Status: Points that are almost dirty have an asterisk.
Continued on next page
Report Menu