22
AUTOPULSE Z-20 Agent Releasing Panel Operator’s Manual (579-1165AR)
Search Overview: Use the Search screen to search for configured points under panel control. Refer to Figure 6
for access levels required for each option inside the Search screen.
Screen Buttons:
Scroll Up
Scroll down
Accept
Return Erase
Figure 11. Search Screen
Search
New
Search
COMMON TROUBLE POINT FOR
NODE: 4
Date
Time
1
ZN1 ZN1
ZN2 ZN2
ZN3 ZN3
New Search: Search for a Specific Point:
The point search keypad opens automatically when the Search
screen is accessed or by pressing the New Search button.
1. Select the desired point type. For example, to select an IDNet
point, press on the IDNet button.
2. Select the desired point number. For example, to select an IDNet
point M1-1-0, enter “1-1-0”.
Note: Point numbers are first generated when the AUTOPULSE Panel
Programmer is used to program points into the panel.
3. Tap Accept to execute the search. Tap Erase to erase the last
character entered. Tap Return to return to the Search screen.
Browse the List of Configured Points
1. If opened, close the keypad by pressing anywhere outside the
keypad. You see a list of all the points configured on the network.
2. Use the Scroll Up and Scroll Down buttons to navigate the list,
tap Accept to get more details on a point, and Return to return to
the System Menu screen.
AUX
ZONE
SIG
FB
IO
IDNet
Pseudo
Analog
LIST
ADDR
New
Search
3
1
2
45
6
7
89
0
M1-1-0
.
IDNet
Search
To Next Page
Loading...
