23
AUTOPULSE Z-20 Agent Releasing Panel Operator’s Manual (579-1165AR)
Diagnostics Overview: Use the Diagnostics function to run tests on the panel and the devices. Refer to Figure 6
for access levels required for each option inside the Diagnostics screen.
Screen Buttons:
Scroll Up
Scroll down
Accept
Return
Figure 12. Diagnostics Screen
Diagnostics Menu
HW Reset Restart WalkTest
USER
BUTTON 1
USER
BUTTON 2
USER
BUTTON 3
Piezo
Silence
Cfig
Download
Next Page
Earth Fault
Search
Earth Fault
Latch
Date
Time
NAC
Miswire Test
Diagnostics Menu
Duplicate
Device Search
Weak Answer
Search
USER
BUTTON 1
USER
BUTTON 2
USER
BUTTON 3
CO
Algorithms
Install
Mode
Previous Page
Date
Time
HW Reset:
Tap Hardware Reset to re-initialize the state of certain hardware components. A hardware reset is typically used to
reset a Class A Trouble after the problem causing the Trouble is resolved.
Note: If you attempt to perform a hardware reset without first fixing the problem that caused the trouble, the hardware reset fails and
the trouble re-appears.
Restart:
Tap Restart to restart the panel by warm start or cold start:
• Warm Start: Preserves the logs and the disabled status of any
points that are in disabled state.
• Cold Start: Clears all history logs and re-enables any points
that were previously disabled.
WalkTest:
Tap WalkTest to open the WalkTest Settings screen, which contains
Walktest groups configured by technicians for use during maintenance
testing. The following functions are available:
• Tap Next Group to select the next WalkTest group.
• Tap Prev Group to select the previous WalkTest group.
• With an item in the WalkTest group selected, tap Select Item to
open a new screen where information and additional functions
for that item are available.
Continued on next page
Restart Menu
WarmStart ColdStart
USER
BUTTON 1
USER
BUTTON 2
USER
BUTTON 3
Date
Time
WalkTest Settings
Next
Group
Prev
Group
Select Item
Walktest Group
Information
Date
Time
Diagnostics
To Next Page
Loading...
