Tyco AutoPulse Z-20 - Alarm Conditions; Viewing the Alarm Condition Details

9
AUTOPULSE Z-20 Agent Releasing Panel Operator’s Manual (579-1165AR)
Viewing the Alarm Condition
Details:
Each alarm condition contains detailed information on the point (or points) that have
triggered it. To access that info:
1. Tap a desired alarm condition from the Fire Alarm in System screen. The alarm condition can either be a point or a
zone containing a variety of points. A point in alarm is shown as an example.
2. Take the necessary actions, using the buttons available at the point details screen. A pull station point is shown as an
example.
Fire Alarm in System
Date
Time
First of 1
Date
PULL STATION 1
FIRE ALARM
ACK
1
Alarm Functions Menu
M1-1-0
PULL STATION 1
Date
Time
Enable
Disable
M1-1
M1-1 PULL STATION
DEVICE ADDRESS: 2-1 TYPE: ADRPUL
IDNET2 CARD
UNIT NUMBER: 0 RUI NUMBER: LOCAL
---------------------------------------------------------------------
PRIMARY STATUS FIRE ALARM
CURRENT DEVICE CORRECT DEVICE
DEVICE ON-LINE
PHYSICAL STATE ABNORMAL
RAW STATE ABNORMAL
ACTIVE STATE OFF
ARMED STATE ARMED
ENABLED STATE ENABLED
Alarm Conditions, Continued