EasyManua.ls Logo

Tyco DN40 - Limited Warranty; Ordering Procedure

Tyco DN40
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GLOBAL HEADQUARTERS | 1400 Pennbrook Parkway, Lansdale, PA 19446 | Telephone +1-215-362-0700
TFP1335
Page 26 of 26
Copyright © 2016 Tyco Fire Products, LP. All rights reserved.
RILSAN is a registered trademark of Arkema, Inc.,
LOCTITE is a registered trademark of Henkel Corporation
valve inspection for a system having a
seawater or brackish water supply is
recommended.)
With reference to Figure 1, make
certain that the Diaphragm is correctly
oriented; otherwise, the DV-5 Deluge
Valve cannot be properly set.
Under-tightening the Diaphragm Cover
Bolts can result in internal and external
leakage.
The V-Ring is attached to the Dia-
phragm at the factory. If, during an
internal valve inspection, the V-Ring
is discovered to be detached from the
Diaphragm, be advised that the V-Ring
is a required valve component and that
detachment will not affect normal valve
operation or performance. Should the
V-Ring become detached, reinstall
it between the Diaphragm and Dia-
phragm Cover concentrically as shown
in Figure 1.
NOTE: Do not apply adhesives, lubri-
cants, or other substances to the Dia-
phragm, V-Ring, or Valve Body.
Limited
Warranty
For warranty terms and conditions, visit
www.tyco-fire.com.
Ordering
Procedure
DV-5 Deluge Valve with European
Conformity Trim
Specify: DV-5 Deluge Valve with Pre-
trimmed FM Approved European Con-
formity Trim, P/N (specify, refer to
Table D )
Accessories
Specify: (description) for use
with (specify size) DV-5 Deluge,
P/N (specify):
Supervisory Switch for
Water Motor Alarm
Control Valve. ................. CEDPV1ASS
Model WMA-1
Water Motor Alarm with
Red Finish Gong. . . . . . . . . . . . . 52-630-2-021R
A through Z Labels for
Attaching to Valve
Components ..................WS00000033
SIZE
A DN40
2 DN50
3 DN80
4 DN100
6 DN150 (168,3 mm)
7 DN150 (165,1 mm)
8 DN200
TRIM
89 EUR
STOP VALVE
00
To be ordered
separately
SWITCH
0 None
1 PS10-1
END CONNECTION
80 Flange x Flange PN10/16
81 Flange x Flange ANSI
82 Flange x Groove PN10/16
83 Flange x Groove ANSI
84 Groove x Groove
85 Thread x Thread ISO 7-1
86 Flange x Groove PN16 (DN200)
87 Flange x Flange PN16 (DN200)
P/N XX — X — XX — XX — X — XX
ACTUATION
00 Wet Pilot Actuation
04 Electric Actuation
06 Dry Pilot Actuation
22
Dry Pilot Actuation
Trim including
Low Air Pressure
Switch
TABLE D
DV-5 DELUGE VALVE WITH EUROPEAN CONFORMITY TRIM
FM APPROVED PRE-TRIMMED AND TESTED ASSEMBLIES
PART NUMBER SELECTION

Other manuals for Tyco DN40

Related product manuals