Need help?Do you have a question about the Tyco iSTAR Ultra and is the answer not in the manual?
General| Model | iSTAR Ultra |
|---|---|
| Type | Control Unit |
| Input Voltage | 12-24 VDC |
| Max Number of Doors | 32 |
| Max Number of Readers | 64 |
| Inputs | 16 |
| Memory | 512 MB RAM |
| Storage | 4 GB Flash |
| Cardholder Capacity | 100, 000 |
| Transaction Storage | 1, 000, 000 |
| Operating System | Linux |
| USB Ports | 1 |
| Communication Protocols | TCP/IP, RS-485 |
| Reader Compatibility | Wiegand, OSDP |
| Operating Temperature | -40°C to 70°C |
| Processor | ARM Cortex A8 |
| Network Interfaces | Ethernet |
| Serial Ports | RS-485, RS-232 |
Covers equipment checks, site readiness, and necessary preparations.
Details the steps for wall and rack mount installations, including safety.
Details electrical ratings and power input/output specifications for components.
Organizes controllers into logical groups for network communication.
Defines the roles of master and member controllers within a cluster.
Describes primary and secondary paths for host communication.
Details power input/output for GCM, ACM, and IP-ACM components.
System power ratings for rack and wall mount configurations.
Covers circuit breaker sizing and external power supply considerations.
Explains the function of reset switches (SW7, SW2) and rotary switch (SW3).
Describes DIP switches for encryption (S1-1) and other settings.
Covers ACM MCU Reset (SW10) and Address Switch (SW32).
Details dry and wet wiring configurations for output relays.
Explains the 24 onboard inputs and various supervision methods.
Describes Fire Alarm Interlock scenarios and modes.
Details the IP-ACM Reset (SW3) and DIP Switch (SW1) settings.
Specifies power requirements and wiring for various signals and connections.
Steps for configuring the IP-ACM in Normal and Standalone modes.
Details the ICU's role in configuration, diagnostics, and troubleshooting.
How to configure member controllers via C•CURE Administration.
Using SW3 to activate diagnostic tests for readers, ports, etc.
To Next Page
