FAI Connections
6–26 iSTAR Ultra Installation and Configuration Guide
State of F, K, and Relay Drive
In addition to the added security gained by using supervision, the state of F, K, and Relay
Drive signals will be available in the C•CURE system.
All three of the inputs, shown in Figure 6-23 on page 6-26, support event triggers based on
their active or inactive states. These event triggers can activate alarms, send emails, run a Roll
Call Report, etc.
If F or K have a supervision error (short, open, or line fault), that will be reported in the normal
way.
Figure 6-23: FAI Inputs (C•CURE 9000)
To Next Page
Loading...
