Access Control Module
6–14 iSTAR Ultra Installation and Configuration Guide
Figure 6-12: Wet NO Latch
Wet Wiring for a Magnetic Lock
Magnetic Locks are normally energized so the GND and NC pins are used in this case. Notice
that jumper is in the Wet position, as shown in Figure 6-13 on page 6-14.
Figure 6-13: WET Magnetic Lock
Table 6-4 on page 6-14 summarizes the function and designation of the ACM LEDs.
Table 6-4: ACM LED Functions
LED Function Comment
DS21 Main Power - Reader Power - J4 12 Vdc
DS52 Main Power - LOCK 1 - J2 12 or 24 Vdc
DS54 Main Power - LOCK 2 - J3 12 or 24 Vdc
To Next Page
Loading...
