Tyco iSTAR Ultra - Readers and Accessory Boards

Overview
iSTAR Ultra Installation and Configuration Guide 7–7
7. Enter the password: iSTAR and then click Login.
8. Make edits that you require to the following fields: IP-ACM Addr, IP-ACM NetMask, IP-ACM
Gateway, IP-ACM DNS, and iSTAR IP Addr.
9. Click Save.
10. Switch SW1-1 to OFF.
11. Reboot the IP-ACM before putting the module back on the network.
Readers and Accessory Boards
The following readers and accessory modules are UL supported:
 Wiegand Signaling Readers:
• SWH-4000, SWH-4100, SWH-4200
• SWH-2100
• SWH-5100
• P345MTR, P345KPMTR
• HID 5365 Series
• HID RP40 multiCLASS
• HID RPK40 multiCLASS
• HID RP15 multiCLASS
 RS-485 RM Bus:
• RM1 series (SWH)
• RM2 series (SWH)
• RM3 series (SWH)
• RM2L series (SWH), RM2L-PI, RM2L-4000, RM2L-NH
 Accessory modules:
• One I/8, I/8-CSI per port
• One R/8 per port
• RM-4, RM-4E, RM-DCM-2
NOTE
Saved changes will not take effect until the board is rebooted.