General Control Module
iSTAR Ultra Installation and Configuration Guide 5–3
Network Connections
Connect a shielded CAT-5E, or better, RJ45 cable to either J5 or J6 (or both for redundancy).
J5 Ethernet up to 1 Gbps (10, 100, 1000)
J6 Ethernet up to 1 Gbps (10, 100, 1000)
There are built in LEDs in the connectors that
indicate the Ethernet Link and Receive Data
signals.
J3 Battery Backup
Not available, for future use.
Switches
SW7- Soft Reset (Reboot)
The SW7 push button saves all data in non-volatile memory and then reboots the unit. It may
take several minutes for the formatting and saving of the data.The iSTAR Ultra is fully capable
of operating without contact with the Host after the reboot.
SW7 should be used to Reset to Factory Default by changing the Rotary Switch (SW3) to ‘D’
and pressing SW7. See Table 5-1 on page 5-4 for Rotary Switch descriptions.
To Clear Memory and Reboot the Unit
1. Set rotary SW3 to D.
2. Press and release switch SW7.
Instructions appear on the LCD in approximately ten seconds.
3. Follow the instructions.
4. Set rotary SW3 back to 0 or F.
5. Press and release SW7, and observe the LCD panel. The unit will reboot, the memory will
be cleared, and the unit will need to be completely re-configured.
NOTE
Rotary switch SW3 set to position A, combined with SW7, does a slightly
less drastic 'reset to factory'. It clears everything but the basic COMM
settings, such as IP address, etc.
To Next Page
Loading...
