Tylo SENSE COMBI ELITE Installation & User Guide

15
&KHFNWKHVWRQHFRPSDUWPHQW
Check the stone compartment at least once annually or as many
times per year as the heater is used per week.
Example: If the unit is used 3 times a week, check the stone
compartment 3 times per year.
How to check the stone compartment:
1. emove all stones from the compartment.
2. emove any small stones, gravel and lime-scale from the
compartment.
3. ut whole, undamaged stones back. eplace damaged
stones with new ones as reuired (see Filling the stone com-
partment, page 13).
Figure 9: Resetting the temperature cut-out
1.
Temperature cut-out water reservoir
2. Temperature cut-out sauna heater
1
2
WARNING! If the stone compartment fi lls up with
gravel and small stones, the tubular element can be
damaged as a result of overheating, as air fl ow will
be insu௻ cient.
7URXEOHVKRRWLQJWKHFRQWUROSDQHO
See instructions supplied with the control panel.
'HVFDOLQJWKHZDWHUUHVHUYRLU
Descale the water reservoir as reuired using
Tyl descaling
agent.
How to descale:
1. emove the herb grille from the herb bowl.
2. Start the steam function (see The section called Use, age
13) and run until the water boils.
3. Switch o󰀨 the heater, and wait for about 5 minutes.
4. Mix 2 cups of descaling agent and pour into the water inlet.
5. eave the descaling agent to work for 1 hour, empty the res-
ervoir and rinse thoroughly.
6. If necessary, repeat the procedure several times until all lime-
scale has been removed.
&OHDQLQJWKHIUDJUDQFHKROGHUDLUKXPLGL¿HUDQGKHUEERZO
Clean the fragrance holder/air humidi er and herb bowl as re-
uired.
To clean the fragrance holder/air humidi er and herb bowl:
ift out the fragrance holder/air humidi er and herb bowl and
rinse them under running water.
Figure 8: Cleaning the fragrance holder/air humidifi
er and herb
bowl
Figure 7: Cleaning the electrodes
1. Electrodes
1
7528%/(6+227,1*
7HPSHUDWXUH6DIHW\6ZLWFKHV
The heaters temperature protection devices:
 PCA - The temperature safety on the CA in the heater is de-
signed to prevent components being damaged by overheating. If
the safety switch is triggered, an error code shows on the control
panel display.
If the overheating switch has activated, the heater cannot be
started again until the temperature has dropped down 6 degrees
(F) on the CA.
 Water reservoir - The temperature safety switch in the reservoir
is designed to protect the heater element from boiling dry. There
is a red reset button under the heater which must be pressed in
(see Fig. 9). If the cut-out has activated, the button will feel sti󰀨
and will click when reset. If the cut-out has not activated and
after resetting, the button will feel springy.
 Heater - The temperature cut-out in the heater protects the com-
ponents and woodwork in the sauna from overheating. There
is a white reset button on the left side of the heater which must be
pressed in (see Fig. 9). If the heater safety switch has activated,
the button will feel sti󰀨 and will click’ when reset.
Information!
When the overheating safety switches activate, always check the
cause of the problem. The life of the elements and CA can be
adversely e󰀨 ected by each overheating. If systems continues to
overheat look at the following: entilation de cient oom vol-
ume Internal heater fault Water reservoir not properly cleaned

Tylo SENSE COMBI ELITE Specifications

General

Brand	Tylo
Model	SENSE COMBI ELITE
Category	Electric Heater
Language	English