Tylo SENSE COMMERCIAL Series

Other manuals for Tylo SENSE COMMERCIAL Series

Questions and Answers:

J
Jared DrakeAug 11, 2025
How to troubleshoot a Tylo SENSE COMMERCIAL when the element in the stone compartment doesn't heat up?
- S
  Shawn AndersonAug 11, 2025
  If the heater element in the stone compartment of your Tylo Heater isn't warming up, first ensure that the temperature settings on the control panel are set correctly for operation in the stone compartment and are higher than the current ambient temperature. Then, check the fuses on the main switchboard, as some of the RB-box/TS-panel fuses may have tripped. Replace or reset them if necessary. If the element still doesn't heat, the heater element itself, the internal RB-box/TS-panel PCB, or the internal temperature cut-out may be faulty, requiring diagnosis and repair by an authorized electrician.
A
Aaron YoungAug 26, 2025
Why do the Tylo SENSE COMMERCIAL Heater fuses trip immediately when I turn on the heater?
- D
  Danielle SmithAug 27, 2025
  If the fuses or ground fault interrupt device on the main switchboard trip as soon as you turn on your Tylo heater, it indicates a potential short-circuit. This could be due to a faulty heater element, lighting connected to and controlled via the RB-box, an insulation fault in the heater element (especially if the heater hasn't been used for a long time), too much water poured on the heater, or another internal heater fault. In any of these cases, do not use the heater. Switch off the main RB-box switchboard trip and disconnect the heater fuses on the main switchboard. An authorized electrician is required to find the fault.
D
Derek HancockSep 2, 2025
What to do if the sauna lights don't turn on in my Tylo SENSE COMMERCIAL Heater?
- S
  Samuel MillerSep 3, 2025
  If the lights in your sauna do not come on when switched on at the control panel of your Tylo Heater, the first step is to check the internal glass fuse in the RB-box and replace it if it's faulty. Ensure you switch off the main power switch on the RB-box before replacing the fuse. If the lighting is connected via the RB-box, verify the connections with the authorized electrician who performed the installation of the RB-box and lighting. If the issue persists, there may be an internal RB-box PCB fault, which requires an authorized electrician to diagnose.
C
Chelsea BerrySep 10, 2025
What to do if my Tylo SENSE COMMERCIAL Heater control panel does not light up?
- M
  mmartinezSep 12, 2025
  If your Tylo Heater control panel isn't lighting up, start by checking if the main power switch is turned on. It should be on the RB-box. Also, inspect the fuses on the main switchboard and replace or reset them if necessary. If these steps don't resolve the issue, there may be a loose contact in the cabling between the RB-box and the control panel. Turn off the RB-box main power switch and reconnect each cable or paired cable to the control panel, then switch the RB-box main power switch back on. If the problem persists, further diagnosis by an authorized electrician is needed, as there could be a faulty 12VDC output, a faulty transformer on the PCB in the RB-box, or a faulty control panel.

Tylo SENSE COMMERCIAL Series Specifications

General

Outer Casing	Stainless Steel
Protection Class	IP24
Type	Heater
Series	SENSE COMMERCIAL Series
Intended Use	Commercial saunas
Stone Capacity	20 kg
Safety Features	Overheat protection
Power Supply	400V
Control	Digital
Installation Type	Wall-mounted