E
MAINTENANCE
E
9
1. Make sure that the amount of fuel in
the fuel tank is sufficient.
2. If air is mixed in the pre-filter or
main filter, unscrew its bleeding
bolt (2), shown in the figure, and
turn the main switch to run the start
motor.
Then, air in the fuel filter is bled
through the bleeding bolt as shown
in the figure above.
If filling the port with fuel before
installing the fuel port, it is not
necessary to bleed the filter.
IMPORTANT
Avoid to run the start motor for over 5
consecutive seconds, but run it several
times at shorter intervals.
CAUTION
UPPER LIMIT
LOWER LIMIT
To Next Page
Loading...
