E
MAINTENANCE
8
(1) Inspection
1. Pull out the dipstick, wipe its tip
and insert it again.
Then, pull it out and check that the
oil level is between the upper and
lower limits.
2. If insufficient, add oil.
▶ INSPECTING AND CHANGING
FRONT AXLE OIL
(2) Changing
1. Unscrew the drain plugs from the
bottom of the axle and left/right
final cases to drain contaminated
engine oil.
Since hot fluid flows out of the
engine first, be careful not to get
burnt.
2. After draining oil, tighten the oil
drain plug.
3. Add the specified amount of the
specified oil through the filler hole.
Do not add front axle oil over the upper
limit level.
Check the front axle oil before starting
the engine or at least in 5 minutes after
the engine is stopped.
When trying to use new fluid from a
different manufacturer or fluid with
different viscosity, drain used fluid
completely before adding new fluid.
IMPORTANT
If oil gets on your skin, it can irritate the
skin and cause a skin condition.
Make sure to clean your skin with soap
and water or hand cleaner thoroughly.
CAUTION
FRONT AXLE OIL DRAIN HOLE
FRONT AXLE OIL GAUGE &
FRONT AXLE OIL FILLER HOLE
To Next Page
Loading...
