E
MAINTENANCE
E
7
(2) Changing
1. Unscrew the drain plug on the
lower section of the transmission to
drain contaminated transmission
fluid.
As hot fluid flows out of the
transmission first, be careful not to
get burnt.
2. After draining fluid, tighten the
transmission fluid drain plug.
3. Pour the specified amount of the
specified transmission fluid through
the filler hole.
The transmission is already filled with
transmission fluid properly.
When using a hydraulic implement, add
more fluid for the amount of the
implement.
IMPORTANT
Do not add fluid over the upper limit
level.
Check the fluid before starting the
engine or at least in 5 minutes after the
engine is stopped.
When trying to use new fluid from a
different manufacturer or fluid with
different viscosity, drain used fluid
completely before adding new fluid.
This tractor uses transmission fluid as
hydraulic oil.
Therefore, keep the oil change interval.
IMPORTANT
If transmission fluid gets on your skin, it
can irritate the skin and cause a skin
condition.
Make sure to clean your skin with soap
and water or hand cleaner thoroughly.
CAUTION
UPPER LIMIT
LOWER LIMIT
TRANSMISSION FLUID DRAIN PLUG
To Next Page
Loading...
