E
MAINTENANCE
6
(2) Changing
• Unscrew the drain plug on the lower
section of the engine to drain
contaminated engine oil.
Since hot oil flows out of the engine
first, be careful not to get burnt.
• After draining oil, tighten the engine
oil drain plug.
• Add the specified amount of the
specified engine oil through the filler
hole.
* There is one engine oil drain hole on
each side of the engine.
(1) Inspection
Perform inspection while the engine is
stopped.
1. Pull out the dipstick, wipe its tip
and insert it again. Then, pull it out
and check that the oil level is
between the upper and lower limits.
2. If the level is below the lower limit,
add fluid.
▶ CHECKING AND CHANGING
TRANSMISSION FLUID
If engine oil gets on your skin, it can
irritate the skin and cause a skin
condition. Make sure to clean your skin
with soap and water or hand cleaner
thoroughly.
CAUTION
Do not add engine oil over the upper
limit level.
Check the engine oil before starting the
engine or at least in 5 minutes after the
engine is stopped.
When trying to use new oil from a
different manufacturer or oil with
different viscosity, drain used oil
completely before adding new oil.
IMPORTANT
ENGINE OIL
DRAIN PLUG
TRANSMISSION FLUID FILLER HOLE
To Next Page
Loading...
