6
1. Press the power button on the
Jump Starter
once and check
that the power level indicator is 3 solid lights (51%) or higher.
2. Take
the BLUE end of the jumper
cable and plug it into the power
bank jump start socket which is
located underneath the black cover.
3. Connect the RED clamp to the
POSITIVE (+) post on the car
battery. The POSITIVE battery
post will be slightly larger than
the NEGATIVE post, and will be
marked with a PLUS (+) sign.
There may also be a RED plastic
protective cover over the positive battery post.
JUMP STARTING:
Black
Red
Black
Red
To jump start the vehicle battery, put the vehicle
in park (neutral if the vehicle has a manual
transmission) and engage the emergency brake.
Locate the battery for the vehicle and follow the
steps listed below.
Jumper cables are color coded, RED for
POSITIVE (+) and BLACK for NEGATIVE (-).
DO NOT mix up the cables or allow the metal
ends to touch together because this may damage the battery,
charging system and/or electronics on a vehicle.
Black
Red
To Next Page
Loading...
Need help?
General
