EasyManua.ls Logo

TYPHOON Q500 - St10 Accessories; Flight Controls

TYPHOON Q500
31 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
ST10 ACCESSORIES
You can install the included and oponal-use Neck Strap to help hold and
support the ST10. You can also install the included and oponal-use LCD
Screen Sun Shade/Shield to help improve viewing in sun light.
QUICK TIP: It may be helpful to apply suitable an-glare screen protector
material over the LCD screen to further improve viewing in sun light.
Moving the le-hand sck to the le will turn (yaw) the nose of the Q500
to the le about the vercal axis. And moving the sck to the right will turn
(yaw) the nose of the Q500 to the right.
FLIGHT CONTROLS
NOTE: The informaon in this and the following secons refers to the
default ‘Mode 2’ control configuraon of the ST10. The le-hand sck on
the ST10 controls the throle (climb/descend) and rudder (yaw le/right)
channels.. When the le-hand sck (also known as the throle sck) is in
the middle posion during flight the Q500 will maintain the current
altude. As you move the sck upward the Q500 will climb, and as you
move the sck downward the Q500 will descend. The farther away from
the middle posion you move the sck the faster the Q500 will climb or
descend.
?
IMPORTANT NOTE: The maximum altude is limited to 400 feet (122
meters) AGL (Above Ground Level) in both Smart and Angle (Pilot) Mode.
And although this limit can be adjusted using the USB interface/program-
mer and soware we strongly recommend using the default limit at all
mes.

Related product manuals