5. When Screen displays radio detection: < user alias or ID >, it is indicating the ongoing of
radio detection. The LED indicator light is red.
6. Waiting for confirmation
7. If the target radio is active in the systern , Ihen il makes a prompt sound, screen will show
that target!wo way radio has responded shortly.
Or if the target radio in the systern is not active, then it makes a prompt sound, screen will
show that target two way radio has no answer shortly.
8. Two way radio returns to user alias or ID screen. If you press
[al
when waiting for con-
firmation, made a prompt sound, two way radio will end ali retry and exit the !WOway radio
detection mode.
Monitor
Using monitoring function to open the target!wo way radio! s microphone (only the user alias
or ID). You can use the function to monitor any sound around target!wo way radio.
Your must allow your two way radio to use this function by programming it.
Start Monitor
Using the Menu:
1. Press [
m
I
to enter the Menu
2. Press
[DorDI
lo Contacts,then press
[1511
to select
3. Press
[DorDI
to The required user alias or ID, then press
[1511
to select
331
l
Or press
[DorDI
key to manual dialing, and then press [
mI
key to select
If there are any calling ID remains before, radio shows the ID and along with the flashing cur-
sor, using the keyboard to edit the ID, press [
mI
key to choose.
Or press
[D
or
D I
key to manual dialing, and then press [
m
l
key to select. Inputting the
user alias or ID, and then press
[Ok]
key to select.
4. Press
[D
oral to select Remote Monitor then press [
mI
to select
5. When two way radio makes a prompt sound, LED light turns green.
6. Waiting for confirmation.
7. Screen displays Monitor successed,
Or screen displays Monitor failed
If success: !WOway radio began to receive voice signals frorn the radios which are being rno-
nitored voice and screen displays two way radio are moniting, until the end of the duration of
the preprogrammed, !WOway radio made a prompt sound, and the LED light puts out, screen
display that monitoring ends.
If failed: two way radio Repeats until reach the preprogrammed attempts.
Contacts setting
Contacts is "address book" for handheld two way radio. Each entry corresponds to an alias or
ID used to start the cali. In addition, each item, according to the different content setling, relate
to three types of cali: graup calling, single cali, ali cali. Your radio support digital address book.
The Contactsl enlries display in the following information
134
To Next Page
Loading...
Need help?
General
