TYT MD-390 - Channel Programming Details; TOT, CTCSS;DCS Settings

TOT
1. Press [ e] key lo enter Ihe menu mode.
2. Press [DorD] key lo utilities, and Ihen press [e] key lo select.
3. Press [DorD] key lo program radio, and Ihen press [e] key lo select.
4. Use the keypad lo enter the correct Program radio password (programmed by software),
and then press [ e] key lo select.
5. Press [DorD] key lo TOT, and Ihen press [e] key lo select. l
6. The screen displays infinile, 15S, 30S ... 555S and other options (increasing 15S each
lime), press [DorD] key lo Ihe corresponding optlon, Ihen press [e I key lo selecl;
if you choose infinile, Ihe screen displays transmit lime close, if you selecl olhers, Ihe
screen display corresponding lime selecled.
CTC/DCS
CTCSSIDCS can only be set on analog mode, including:
• CTCSS/DCS encoding
• CTCSS/DCS decoding
Encode I
1. Press [ e I key lo enler Ihe menu mode.
2. Press [D or D] key lo ulililies, and then press [ e I key lo select.
3. Press [D or D] key lo program radio, and Ihen press [e I key lo select.
151
116
4. Use Ihe keypad lo enler Ihe correct Program radio password (programmed by software),
and Ihen press [ e] key lo select.
5. Press [D or D I key lo CTCSS/DCS, and Ihen press [ e I key lo select.
6. Press [DarDI key lo CTCSSIDCS encoding, and Ihen press [e I key lo select.
7. Screen display off and a set of CTCSSIDCS encoding value, press [D orD] key lo off,
and Ihen press [ e] key lo select, and Ihere will be no CTCSS/DCS encoding value,
screen displays CTCSS/DCS encoding value off; press [DarDI key lo CTCSS/DCS
encoding value, and Ihen press [ e] key lo selecl, Ihen seI the corresponding value,
screen displays the corresponding CTCSSIDCS encoding value.
Decode
1. Press [ e I key lo enter the menu mode.
2. Press [DorD] key lo utilities, and Ihen press [m] key lo select.
3. Press [DorD] key lo program radio, and Ihen press [e] key lo select.
4. Use Ihe keypad lo enter Ihe correcl Program radio password (programmed by software),
and Ihen press [ e] key lo select.
5. Press [DarDI key lo CTCSSIDCS, and then press [e I key lo select,
6. Press [DarDI key lo CTCSS/DCS decoding, and Ihen press [e] key lo selecl.
7. Screen display off and a seI of CTCSSIDCS decoding value, press [DorD] key lo off,
and Ihen press [ e] key lo select, and Ihere will be no CTCSS/DCS decoding value,
screen displays CTCSS/DCS decoding value off; press [DorD] key lo CTCSS/DCS