Need help?Do you have a question about the TYT TH-UVF 9 and is the answer not in the manual?
General| Brand | TYT |
|---|---|
| Model | TH-UVF 9 |
| Category | Transceiver |
| Language | English |
Important notes and warnings regarding safe and effective battery charging procedures.
Caution regarding conductive metals touching battery terminals and potential hazards.
Step-by-step guide for attaching the battery pack to the transceiver.
Instructions for attaching the antenna to the transceiver connector.
Steps to attach the belt clip to the radio using screws.
Allows direct frequency input and storage of channels.
Configures scanning behavior and modes (TO, CO, SE).
Allows transmission on a sub-band while operating on the main band.
Configures voice-activated transmit and its sensitivity.
Allows selection of high or low transmit power.
Adjusts the squelch level to mute background noise.
Enables monitoring of both master and sub bands simultaneously.
Sets a limit on continuous transmission duration for safety.
Prevents accidental transmission on an occupied channel.
Monitors two channels simultaneously, even during FM radio use.
Automatically locks the keypad to prevent accidental operation.
Configures repeater offset frequency and shift direction for extended range.
Manages CTCSS/DCS tone coding, scanning, and 1750Hz tone calling.
Scans for CTCSS/DCS tones used by other stations.
Activates a 1750Hz tone burst for repeater access.
Manages voice companding and scrambler groups for enhanced clarity and security.
Configures PTT ID transmission using MSK or DTMF signaling.
Activates an emergency ring and transmission sequence.
Locks or unlocks the keypad to prevent accidental key presses.
Swaps transmit and receive frequencies.
Activates a 1750Hz tone burst for repeater access.
Stores and deletes memory channels for frequencies and settings.
Covers FM radio operation, mode selection, and frequency scanning.
Describes the process of cloning settings between two radios using a cable.
Details on configuring and using DTMF signaling for calls and ID.
Details on configuring and using MSK signaling for calls and ID.
Details on configuring and using 2-Tone signaling for calls.
Details on configuring and using 5-Tone signaling for calls.
Describes disabling the radio remotely via DTMF code.
Describes remotely disabling transmission via DTMF code.
To Next Page
