User's
Manual
DETAILED
FUNCTION
DESCRIPTIONS
ADVANCED
FUNCTIONS
http://www.tyt888.com
DETAILED
FUNCTION
DESCRIPTIONS
1)
Scan & Scan Mode setting (SCAN&SCANS—MENU 1&17)
Functions:
under VFO/IVIR/CH mode, TH-UVF9 allows you to scan the entire current
operating band and memory channels.
Enter
Menu
1^' and
press
[ B ] key to start
scanning.
When you have started scanning, press [ ES ] / [ ] key to change direction. And it
will halt on a signal It encounters, press PTT key to stop scanning; Press
MONI
key to
stop scanning temporarily; Press [ B ] key again to exit the scanning function.
Scanning operation is basically the same in each of the above modes. Before you begin,
take a moment to select the way in which you would like the scanner to halt on a signal.
Enter
Menu
17'" to set
scan
mode. Default: TO.
Three options for the scan mode are available under VFO mode:
TO:
In this mode, the scanner will halt on a signal it encounters, and will hold there for
some time. If you do not take action to disable the scanner within the time period,
the scanner will resume even if the stations are still active.
CO:
In this mode, the scanner will halt on a signal it encounters, and will hold there if
the stations are still active. And after the carrier has dropped, the scanner will
resume.
SE:
In this mode, the scanner will halt on a signal it encounter, it will not restart
automatically; you must manually re-initiate scanning if you wish to resume.
To Next Page
Loading...
Need help?
General
