7)
LED Display Mode (LED—MENU 7)
Function:
select ttie LED/Keypad Lamp mode.
Enter
IMenu
7* to
select
LED display mode. Default: AUTO.
ON:
LED display ligiits all the time.
AUTO:
Illuminates the LED when any key is pressed and after 3s the light is off.
OFF:
Disable the LED lamp.
8)
Backlight Brightness setting (LIGHT—MENU 8)
Functions:
choose LED backglight brightness.
Enter
Menu
8* to
select
backlight
brightness.
Default:
C0L0R2.
COLOR1:
brighter.
COLOR2: default setting.
COLOR3: darker.
9)
Keypad Beeper setting (BEEP—MENU 9)
Functions:
enable/disable the keypad beeper.
Enter
Menu
9'" to set keypad beeper. Default: ON.
10)
Automatic Number Identity (ANI—MENU 10)
Functions:
sending ID code when TH-UVF9 transmits, the others can receive it directly
on the display if they also hate A I futiction.
Enter
Menu
10* to set ANI. Default; OFF.
11)
Transmitter Time-Out Timer (TOT—MENU 11)
Functions:
the TOT feature provides a safety switch which limits transmission to a
pre-programmed value. This will promote battery conservation by not
allowing you to make excessively-long transmissions, and in the event of
a stuck PTT switch it can prevent interference to other users as well as
battery depletion.
Enter
Menu
11'" to set TOT. Default: OFF.
12)
Busy Channel Lock-Out (BCLO—MENU 12)
Functions:
the BCLO feature prevents the radio's transmitter from being activated if a
signal strong enough to break through the "noise" squelch is present. On a
frequency where stations using different CTCSS or DCS codes may be
active, BCLO prevents you from disrupting their communications
accidentally (because your radio may be muted by its own tone decoder).
Enter
Menu
12'*' to set
BCLO.
Default: OFF.
OFF:
Disable BCLO feature.
WAVE:
the radio's PTT will be prevented only if the frequency is busy used.
CALL: the radio's PTT will be prevented only the frequency and tone coder is the same.
13)
Transmit Over Beeper (ROGER—MENU 14)
Functions:
sending a beeper to inform the receiver TX is over.
Enter
Menu
14'" to set
ROGER.
Default: OFF.
133
To Next Page
Loading...
Need help?
General
