DCS CODE
023
074
172
265
371
503
662
025
114
174
266
411
506
664
026
115
205
271
412
516
703
031
116
212
274
413
523
712
032
122
223
306
423
526
723
036
125
225
311
431
532
731
043
131
226
315
432
546
732
047
132
243
325
445
565
734
050
134
244
331
446
606
743
051
143
245
332
452
612
754
053
145
246
343
454
624 -
054
152
251
346
455
627
-
065
155
252
351
462
631 -
071
156
255
356
464
632 -
072
162
261
364
465
645
-
073
165
263
365
466
654 -
Function
2: TONE Searcli Scanning
In operating situations wtiere you don't l<now ttie CTCSS/DCS tone being used by
another station or stations, you can command the radio to listen to the incoming signal
and scan in search of the tone being used.
Enter
IMenu
31^/32"" to start
CTCSS/DCS
searching.
If the Tone scan feature does not detect a tone or code, it will continue to scan
indefinitely. When this happens, it may be that the other station is not sending any tone.
You can press PTT key to halt the scan at any time.
You also can press
iVIONI
key during Tone scanning to listen to the (muted) signal from
the other station. When you release the
iVIONI
key. Tone scanning will resume.
Tone Scanning works either in the VFO or MR modes.
Function
3: TONE Calling (1750Hz)
If the repeaters in your country require a 1750Hz burst tone for access (typically in
Europe),
you can press and hold
CALL
key for 2s and transmitter will automatically be
activated,
and a 1750Hz audio tone will be superimposed on the carrier. Once access
to the repeater has been gained, you may release
CALL
and use PTT key for activating
the transmitter.
22)
VFO Step setting (STEP—MENU 29)
Functions:
setting of the synthesizer steps
Enter
[Menu
29* to set VFO
step.
Available Values: 5/6.25/10/12.5/25/50/100 kHz
M39
I
To Next Page
Loading...
Need help?
General
