34
User’s Manual
STORAGE, VACATION AND MOVING
If the unit is to be stored, moved or not used for extended periods, it
will be necessary to drain the system of water.
Electrical Shock Hazard. Disconnect power
before servicing. Before operating replace all
panels. Failure to do so can result in death or
electrical shock.
1. Disconnect power from the unit.
2. Remove ice from the storage bin.
3. Shut off water supply at the main water source.
4. Disconnect the inlet and outlet lines to the water valve and allow
them to drain.
NOTE
Back panel must be removed prior to disconnecting the
water lines.
If the ambient temperature is expected to drop below 45°F,
drain all water from the unit to prevent freezing damage not
covered by the warranty.
NOTE
The use of anti-freeze or other products of this nature is
not necessary and is not recommended.
5. Reconnect inlet and outlet lines to the water valve.
6. Replace back panel.
7. Drain water from the water trough and drain line by removing the
overflow tube (see Figure 34).
Body_UM.qxd 12/17/04 9:16 AM Page 34
To Next Page
Loading...
Need help?
General