U-Line CLR2060 User Manual

6
User’s Manual
Follow these guidelines when installing drain lines to prevent water from
flowing back into the ice maker storage bin and/or potentially flowing
onto the floor causing water damage:
Gravity Drain
• Drain lines must have a 5/8" inside diameter.
• Drain lines must have a 1" drop per 48" of run (1/4" per foot) and
must not create traps.
• The floor drain must be large enough to accommodate drainage
from all drains.
• Insulate the bin drain line to prevent condensation.
CLR2060 With Factory Installed Drain Pump
NOTE
Before installing your U-Line CLR2060 With Factory Installed
Pump, it is extremely important to check and test all hose
connections at the drain pump. There is a possibility that
hose connections may have loosened during shipment.
To prevent accidental electrocution, make certain that the
floor surfaces surrounding the unit are dry whenever power
is removed from, or applied to the unit.
1.
Make certain the unit is not plugged into an electrical outlet.
2.
Carefully push the power cord grommet through the hole in the
back panel.
UL184-1
POWER
CORD
DRAIN
FITTING
BACK
PANEL
GROMMET
SCREWS
!
WARNING
Body_UM.qxd 12/17/04 9:16 AM Page 6

U-Line CLR2060 Specifications

General

Brand	U-Line
Model	CLR2060
Category	Ice Maker
Language	English