UAV-1002156-001
ECCN 7A994 Page 27 | 31
Altitude must be pre-flight cross-checked by comparing the aircraft’s
altimeter with the GPS altitude displayed on the EFB application.
9.5 Transmit Control
According to UK CAP1391 regulations, transmission must be deactivated
when used on an aircraft with an air traffic control radar beacon system
(ATCRBS)Mode-S transponder.
10 Firmware Update Procedure
10.1 Configuration Setup
Configuration of the SkyEcho 2 is accomplished by logging on to the device
directly from a computer or mobile device using the SkyEcho 2 internal Wi-
Fi hotspot. No additional application is necessary.
The following are procedures for updating the SkyEcho 2 firmware. You
may be provided with one or two files to update, corresponding to the
procedures below.
To Next Page
Loading...