Need help?Do you have a question about the Ubiquiti UAP-IW and is the answer not in the manual?
General| Model | UAP-IW |
|---|---|
| Category | Wireless Access Point |
| Frequency Band | 2.4 GHz, 5 GHz |
| Ethernet Ports | 1 |
| Buttons | Reset |
| Power Method | 802.3af PoE |
| Supported Voltage Range | 44-57VDC |
| Max TX Power | 20 dBm |
| Wireless Security | WEP, WPA-PSK, WPA-Enterprise (WPA/WPA2, TKIP/AES) |
| BSSID | Up to 4 per Radio |
| Operating Humidity | 5 to 95% Noncondensing |
| VLAN | 802.1Q |
| Guest Traffic Isolation | Supported |
| Concurrent Clients | 100+ |
| Wireless Speed | 300 Mbps |
| Mounting | Wall |
| WMM | Yes |
Lists the items included in the package, such as the UAP-IW, cover plate, and quick start guide.
Lists the necessary hardware and tools for installing the UniFi AP.
Outlines software and operating system prerequisites for setup.
Illustrates a typical network setup with the UAP-IW and other UniFi devices.
Describes the PoE Out + Data, Data, and PoE In + Data Ethernet ports on the UAP-IW.
Explains the reset button's functions for restarting and restoring factory defaults.
Instructions on removing the cover plate from the UAP-IW.
Guide on connecting the Ethernet cable to the PoE IN + DATA port.
Steps for placing the UAP-IW into the wall box and managing the cable.
Instructions on securing the mounting plate with screws for proper cover plate fitting.
Steps for attaching the cover plate to the installed UAP-IW.
Describes the process of logging into the UniFi Controller management interface.
Details the physical, electrical, and performance specifications of the UAP-IW.
Essential safety guidelines and warnings for product usage.
Precautions regarding electrical connections and servicing.
Outlines the conditions under which the warranty is valid or void.
Explains the process for product returns and the requirement for an RMA number.
Details the FCC rules and conditions for device operation and interference.
Specifies compliance with Canadian ICES-003 and RSS standards.
Warns about the required antenna separation distance for RF exposure compliance.
Explains the CE marking and European directive for waste disposal.
Declares compliance with essential requirements of Directive 1999/5/EC.
Provides URLs for product support, community, and downloads.
To Next Page