Ublox SARA-R5 Series

EVK-R5 - User guide
UBX-19042592 - R06 Appendix Page 14 of 23
C1-Public
B Setting up cellular packet data connection on
Windows
This section describes how to set up a packet data connection on Windows 10 using the operating
system’s TCP/IP stack and EVK-R5. This is also referred to as a dial-up connection.
B.1 Install a new modem from the control panel
1. Open the Control Panel and select “Phone
and Modem”, go to the Modems tab and
select “Add”.
This opens the Add Hardware Wizard.
2. Tick the “Don’t detect my modem”
checkbox. Then select “Next”.