Uconnect 5.0 NAV Owner's Manual

Shuffle
Press the “Shuffle” button to play the selections on the
USB or Bluetooth (if supported) device in random order
to provide an interesting change of pace. Press the button
a second time to turn this feature off.
Repeat
Press the ⬙Repeat⬙ button to replay the selection on the
USB or Bluetooth (if supported) device. Press the button
a second time to turn this feature off.
Audio
Refer to “Operating Radio Mode” for adjusting the audio
settings.
USB Mode
USB Mode is entered by either inserting a USB Jump
Drive cable into the USB port or by pushing the MEDIA
button located below the display. Once in MEDIA mode,
press the “Source” button and select USB.
NOTE:
• The Uconnect 5.0/5.0 NAV system supports only
FAT32, or ExFAT formatted USB devices, and does not
support devices with a capacity higher than 64 GB.
• The Uconnect 5.0/5.0 NAV system does not support
USB hubs connected to the USB port of the vehicle.
Connect your multimedia device directly to the USB
port, using the specific connection cable for the device
if necessary.
Inserting USB Device
Gently insert the USB device into the USB Port. If you
insert a USB device with the ignition ON, the unit will
switch to USB mode and begin to play when you insert
the device. The display will show the Artist and Title
name, and index time in minutes and seconds.
Browse
Press the “Browse” button to select Artist, Albums,
Genres, Songs, Playlists or Folders from the USB device
only. Once the desired selection is made you can choose
from the available media by pressing the button. Press
the “Exit” button if you want to cancel the browse
function.
AUX Mode
AUX Mode is entered by inserting an AUX device using
a cable with a 3.5 mm stereo audio jack into the AUX port
4
MEDIA MODE 23

Uconnect 5.0 NAV Specifications

General

Brand	Uconnect
Model	5.0 NAV
Category	Car Receiver
Language	English