or by pushing the MEDIA mode button located below the
display. Once in MEDIA mode, press the “Source” button
and select AUX.
Inserting Auxiliary Device
Gently insert the Auxiliary device cable into the AUX
Port. If you insert an Auxiliary device with the ignition
ON, the unit will switch to AUX mode and begin to play
when you insert the device cable.
Controlling The Auxiliary Device
The control of the auxiliary device (e.g., selecting play-
lists, play, fast forward, etc.) cannot be provided by the
radio; use the device controls instead. Adjust the volume
with the VOLUME rotary knob, or with the volume of the
attached device.
NOTE: The vehicle radio unit is acting as the amplifier
for audio output from the Auxiliary device. Therefore if
the volume control on the Auxiliary device is set too low,
there will be insufficient audio signal for the radio unit to
play the music on the device.
Bluetooth Mode
Bluetooth Streaming Audio (BTSA) or Bluetooth Mode is
entered by pairing a Bluetooth compatible device con-
taining music, to the Uconnect system.
Before proceeding, the Bluetooth device needs to be
paired through Uconnect Phone to communicate with the
Uconnect System.
NOTE: See the pairing procedure in this manual for
further details.
Once the Bluetooth device is paired to the Uconnect
System, push the MEDIA button. Once in MEDIA mode,
press the “Source” button and select Bluetooth.
24 MEDIA MODE
To Next Page
Loading...
Need help?
General
