Using Arrival Times
You can set your navigation system to ask you if you
need to arrive at a particular time when you plan a route.
Push the “Status bar” button in the
Settings menu, to enable or disable
arrival time notifications.
Select how the status bar should be
displayed, then press next.
To enable arrival time notifications,
select “Leeway,” then press “Done.”
After entering a destination, press the “YES” button
when asked about an arrival time to enter a preferred
arrival time.
The navigation system calculates your arrival time and
shows you whether you will arrive on time.
You can also use this information to work out when you
need to leave. If route planning shows that you will
arrive 30 minutes early, you can wait and leave in
30 minutes time, rather than arrive early.
Your arrival time is constantly recalculated during your
journey. The status bar shows whether you will arrive on
time or if you are going to be late, as shown below:
You will arrive 55 minutes before the arrival time you entered.
If the estimated arrival time is more than five minutes before the time you entered, it is
shown in green.
You will arrive 3 minutes before the arrival time you entered.
If the estimated arrival time is less than 5 minutes before the time you entered, it is shown
in yellow.
You will arrive 19 minutes late. If the estimated arrival time is later than the time you
entered, it is shown in red.
8
NAVIGATION 49
To Next Page
Loading...
Need help?
General
