79
5. 5mm Allen Key
This tool is to be used for loosening/
tightening Bolts for removing and
retting of rider seat.
: Pillion seat needs to be
removed before removing rider seat.
6. Star Head Screwdriver
This tool is used for loosening /
tightening Battery terminal bolts only if
required.
: Negative(-ve) terminals
must be removed rst, and during
installation, Positive(+ve) terminal be
connected rst.
This tool is also to be used for
adjusting headlamp beam level
after removing the LHS front fork
back cover.
7. Pre-Load Adjuster
This Special tool is to be used for
adjusting the front suspension
pre-load.
: Make sure both right and left
front suspension pre-load adjuster
is equal or else there would be non-
uniform wear and tear and discomfort
in riding.
ALIGN
RH LH
To Next Page
Loading...