UNI-T UT2000 series

UNI-T
®
Uni-Trend Group Limited
5. Click the [Data Interface] knob to pop up the following screen.
6. Click Series on the above screen so the oscilloscope can transmit continuously as
indicated below. You can now control the oscilloscope.
7. When operation is complete press [CLOSE] to close this screen.
Note: When starting step 5 after completing step 4, you can select [Function] and then
[Remote Control] in the menu bar instead of clicking [Data Interface]. The following
screen will pop up to allow control of the oscilloscope but no waveform is displayed.
This operation is similar to “Serial Interface Controls” explained below.
10
Uni-Trend Group Limited
. All right reserved 2007
_
__________________________________________________________________________________________
User Manual for UT2000_3000 Series Computer Testing & Control Software