UNI-T
®
Uni-Trend Group Limited
Note: This process may take several seconds.
4. Click the [Function] knob on the menu bar than select remote control. The
following screen will appear. You can now control the oscilloscope.
Important: The above screen will not display waveform. Operation of this screen will
be indicated in the oscilloscope.
5. At the end of operation press [CLOSE] to close this screen. To switch to USB
connection follows the steps for USB connection stated above. When you have
finished all operations, press [CLOSE] to switch off the UT2000_3000 Series
Digital Storage Oscilloscope software, then power off the oscilloscope and
disconnect the USB lead and RS-232 power cord.
12
Uni-Trend Group Limited
. All right reserved 2007
__________________________________________________________________________________________
User Manual for UT2000_3000 Series Computer Testing & Control Software
To Next Page
Loading...
Need help?
General
