Note
If the Meter does not display 00.00 when it is at 66A range, press ZERO to
zeroing. After zeroing, it allows 10 digits bouncing reading.
When the Meter is at 1000A , it displays 0 and it is not allowed to press ZERO
to zeroing.
When current measurement has been completed, disconnect the connection
between the conductor under test and the jaw, and remove the conductor away
from the transformer jaw of the Meter.
conductor at a time, to meausre more than one condutor at a time will cause deviation.
Model UT207/208: OPERATING MANUAL
31
To Next Page
Loading...
Need help?
General
