D. Testing for Continuity (see figure 6)
To avoid damages to the Meter or to the devices
under test, disconnect circuit power and
discharge all the high-voltage capacitors before
measuring continuity.
To test for continuity, connect the Meter as follows:
Insert the red test lead into the V Hz terminal
and the black test lead into the COM terminal.
Set the rotary switch to and press
SELECT button to select measurement mode.
The buzzer sounds if the resistance of a circuit
under test is less than 30 .
The buzzer may or may not sound if the
resistance of a circuit under test is between 30
to 100 .
The buzzer does not sound if the resistance of
1.
2.
3.
4.
5.
Red Black
Warning
Figure 6
Model UT207/208: OPERATING MANUAL
24
To Next Page
Loading...
