Model UT60H: OPERATING MANUAL
17
C. DC Current Measurement (see figure 4)
( figure 4)
Warning
Never attempt an in-circuit current measurement
where the open circuit voltage between terminals
and ground is greater than 60V DC or 30V rms.
If the fuse burns out during measurement, the Meter
may be damaged or the operator himself may be hurt.
Use proper terminals, function, and range for the
measurement.
When the testing leads are connected to the current
terminals, do not parallel them across any circuit.
Before the Meter is connected in serial to the in-circuit
being tested, turn off the power of the in-circuit..
Measurement Operation(3)
To Next Page
Loading...
