Model UT60H: OPERATING MANUAL
29
Sleep Mode
To preserve battery life, the Meter automatically turns
off if you do not turn the rotary switch or press any button
for around 30 minutes. The Meter enters into sleep mode
The Meter can be activated by turning the rotary switch or
pressing any button except POWER and Low imp. 200KΩ
button.
To disable the Sleep Mode function, press MAX MIN or
REL button while turning on the Meter.
Operation of Hold Mode
Warning
To avoid possibility of electric shock, do not use Hold
mode to determine if circuits are without power. The
Hold mode will not capture unstable or noisy readings.
To use Hold mode, follow the following procedure:
l Press HOLD to enter Hold mode; the Meter beeps.
l Press HOLD again or RANGE or Hz % or turn
the rotary switch to exit Hold mode; the Meter beeps.
l In Hold mode, is displayed.
l Press and hold HOLD button when turning on the
Meter to display and keep full icons, and entering
Hold mode.
HOLD
To Next Page
Loading...
Need help?
General
